WHITEWATER R.C.

Whitewater WI radio control club


You are not connected. Please login or register

SB NAMIC 2.4

View previous topic View next topic Go down  Message [Page 1 of 1]

1 SB NAMIC 2.4 on 1/1/2012, 5:01 pm

sblock

avatar
My latest project

I HOPE IT FLY's

If it does I will do some graffics

36grams with battery









2 Re: SB NAMIC 2.4 on 1/1/2012, 5:37 pm

rwcd

avatar
It will fly.

3 Re: SB NAMIC 2.4 on 1/1/2012, 6:28 pm

dcs155

avatar
looks cool steve!! Doesn't look like there's enough there to glue it self back together when ya break it Very Happy

4 Re: SB NAMIC 2.4 on 1/1/2012, 6:39 pm

sblock

avatar
The big trick will be not to break it. YA RIGHT!!cherry

5 Re: SB NAMIC 2.4 on 1/1/2012, 6:51 pm

dcs155

avatar
I'm gonna build jasons dynex tomorrow, I have a hard time with this little stuff!! Must need smaller hands Very Happy Did you use little z bends or do the shrink tube ends on yours??

6 Very Cool ! on 1/2/2012, 5:35 am

teeceeveecee

avatar
Hi Steve:

Very cool stuff ! Set those ailerons up as flaparons and have some great fun.

Tom

7 Re: SB NAMIC 2.4 on 1/2/2012, 8:15 am

rwcd

avatar
dcs155 wrote: I'm gonna build jasons dynex tomorrow, I have a hard time with this little stuff!! Must need smaller hands Very Happy Did you use little z bends or do the shrink tube ends on yours??
I made thesmall z bends on mine.

8 Re: SB NAMIC 2.4 on 1/2/2012, 9:41 am

sblock

avatar
Dave I used Z bends the trick is when you ca the wire to the carbon and shrink tube is not to get the ca where you don't want it BE CAREFUL

I would like to see a better way of doing it. also make sure you have the servo centered properly before you set it. The other thing you can do is put a U shape bend at the opposite end of the rod for small adjustments. Be careful of sub trim and travel adjust not to bind the servo. also there are multiple holes in the servo use the smallest one possible for undo slop

I would ca the opposite end of the servo for saftey do the servo end first and install don't forget to install rod guides on elevator and rudder rods get all that setup before final ca

Hope this helps Steve

9 Re: SB NAMIC 2.4 on 1/2/2012, 2:12 pm

dcs155

avatar
Sounds good, Thanks Steve!!

10 Re: SB NAMIC 2.4 on 1/2/2012, 6:21 pm

rwcd

avatar

11 Re: SB NAMIC 2.4 on 1/2/2012, 8:45 pm

KenD

avatar
when do the Plans go on sale? I'm still intrested in making one or two or three??? Laughing

12 Re: SB NAMIC 2.4 on 1/3/2012, 3:59 pm

sblock

avatar
After I fly it, to prove it out.

Then I will post a pdf file for club members only please.sunny

PS there is a New YAK 55 on the bench also!!!!!!!!!

Sponsored content


View previous topic View next topic Back to top  Message [Page 1 of 1]

Permissions in this forum:
You cannot reply to topics in this forum