Whitewater WI radio control club

You are not connected. Please login or register

Swap meet Today

Go down  Message [Page 1 of 1]

1 Swap meet Today on 1/6/2013, 6:45 pm


Everybody going to tell what they got today. Very Happy

2 swap meet toys on 1/7/2013, 8:11 am

Roger Beltmann

I picked up a switch harness for the ignition system of my new gas airplane. Heavy duty construction, charge jack and a built in LED to remind you of ignition status. Hooked up the seventh servo to the retract channel for an electronic choke.Works great and doubles as a kill switch.

3 Re: Swap meet Today on 1/7/2013, 2:10 pm


Not much. New hand fuel pump. Frank found me some wheelpants for my Cap. Smile Smile

4 Re: Swap meet Today on 1/10/2013, 5:10 pm


Is your project a secret or did I miss A post

Last edited by sblock on 1/14/2013, 5:13 pm; edited 1 time in total

5 Secret project on 1/10/2013, 6:21 pm

Roger Beltmann

Hi Steve. I'd post pictures but don't know how. The airplane is a seagull edge 540. Engine is a RCG 26cc. Radio is a hitec laser 6. Six metal gear high torque servos for control surfaces and choke. Standard servo for throttle. I had to rewire one elevator servo for reverse rotation to work with a Y harness. 3000ma. 6 volt for radio. 4.8 volt for ignition. The engine assy. weighs 45 oz. so I was able to mount the elevator servos in the rear of the airplane without screwing up the cg. It's mostly finished except for fuel and ignition systems. I'll try and bring to the next meeting. Thanks for the interest,Roger

6 Re: Swap meet Today on 1/12/2013, 3:32 pm



If its like the SEAGULL Edge I had (60 to 90) size keep it a little nose heavy for your first flight. Would snap out of a loop if to much elevator is used. Flew pretty good Looked good to. The 26cc should be more than enough power. looking forward to seeing it fly


7 Edge 540 on 1/13/2013, 5:33 am

Roger Beltmann

Hi Steve. Is that the airplane you sold to Jeff? The new version does not have tail rigging. It uses an aluminum tube inside the stabilizer. Really cleans up the rear end!

8 Re: Swap meet Today on 1/14/2013, 5:13 pm


That's the one

Sponsored content

Back to top  Message [Page 1 of 1]

Permissions in this forum:
You cannot reply to topics in this forum